Brushed Brass Cabinet Pulls

Brushed Brass Cabinet Pulls: Choosing Your Size

Center-to-center size determines fit and proportion, and this range runs from compact drawer sizes up to 47 inches for appliance panels and oversized doors. Replacing existing hardware, match your current center-to-center spacing to reuse the drilled holes. For new cabinetry, size to the opening rather than a length you simply like the look of.

• Brushed brass cabinet pulls 5 inch: suited to standard drawers and cabinet doors in the 15 to 18 inch range. This is the size most homeowners default to for a balanced, proportional look.
• Brushed brass cabinet pulls 7 inch: better for wider drawers, larger cabinet doors, and openings where a longer grip reads more comfortably.
• As a general rule, a pull should span roughly one third of the drawer width. A 15 inch drawer suits a 5 inch pull; a 21 inch drawer suits a 7 inch pull.
• Beyond 7 inch, this collection continues into extra long drawer pulls, sized up to 47 inches for wide drawer banks, tall doors, and appliance panels, all in the same brushed brass finish.

Every pull in this range is built from solid brass rather than a plated substitute, so the finish holds up on daily-use cabinet hardware, and brushed brass stays consistent at contact points rather than wearing through. Browse the full brass cabinet hardware pulls range for more styles at each size.

Where Brushed Brass Pulls Work Around the Home

Cabinet pulls aren't limited to the kitchen. The same center-to-center sizing logic applies wherever you have drawers or cabinet doors to open.

• Kitchens: cabinet fronts, drawer banks, and appliance panels are the most common application, typically in the 5 inch to 7 inch range with longer sizes for wide banks.
• Bathrooms: vanity drawers and cabinet doors usually take the same 5 inch pulls used in kitchens, alongside brass cabinet knobs on smaller doors where a pull would look oversized.
• Bedrooms and living spaces: dressers, wardrobes, sideboards, and built-in storage all use the same hardware, just sized to the piece rather than a fixed kitchen standard.
• Laundry and utility rooms: cabinetry here sees frequent, often wet-handed use, which is where a brushed finish that resists showing fingerprints and water spots earns its keep.
• Wherever a cabinet door swings wide enough to strike a wall or neighboring unit, a brass door stopper in the same finish protects the wall without introducing a mismatched piece of hardware.

Sourcing Coordinated Brass Hardware

Brass finish tone varies between manufacturers even when listed under the same name, so hardware sourced separately from different suppliers rarely matches exactly once installed side by side. Sourcing pulls, knobs, and fittings from one range at GetSwitches removes that risk, though it still matters which named finish you pick within that range.

• Brass kitchen knobs are solid brass from the same range as this pull collection, but satin brass and brushed brass are distinct finishes, so check the specific finish before pairing knobs with these pulls on the same run of cabinetry.
• If your kitchen uses a satin rather than brushed finish, satin brass kitchen knobs are built to that standard specifically, rather than approximating it from a brushed brass line.
• Buying pulls, knobs, and accessories from one supplier still means one point of contact and one production standard, even across different named finishes, which is simpler than reconciling mismatched brass tones from separate suppliers later.